More Info
Self Installation Guide
Fitting the S7 BigBox using dynobolts
Before installing your GE KeySafe™ please read all the fitting instructions and recommendations enclosed within the packaging to conform to the insurance acknowledgement. Should you experience difficulties when fitting your KeySafe, please call our Sales Support team on 01905 770 333, who will be happy to help.
Supra UK Limited have provided the best fittings for the installation of your GE KeySafe™ and recommend that you fit your GE KeySafe™ in a covert position using a 5-7 digit code.
Prior to fitting, follow instructions to enlarge the 4 holes in the back of the KeySafe, enabling the bolt thread to pass through.
Following instructions, mark and drill 4 holes into the brickwork taking care NOT to drill into the mortar but into the solid part of the brick if possible. Ensure the nuts are finger tight on the dynobolts provided and tap them into the drilled holes in the wall, taking care not to damage the thread to the bolt.
Then using a socket set, tighten the nuts to the dynobolts by 3 turns. This will ensure the dynobolts are secure and the sleeve is tight to the bolt. After you have done this remove the nuts from the dynobolts completely and set aside.
Now offer the vault of the GE KeySafe™ to the wall over the dynobolts and replace the nuts.
Again using your socket set, tighten each of the four nuts to the dynobolts carefully. For a secure fixing ensure the nuts are tightened as much as possible.
For the S7 Big Box GE KeySafe™ you will need a 10mm socket.
Simply enter your code and replace the lid.
Please remember that you will need to enter your code to open AND close your GE KeySafe™.
Click here for a printer friendly version
Fitting the C500, Permanent and Slimline using masonry screws
Before installing your GE KeySafe™ please read all the fitting instructions and recommendations enclosed within the packaging to conform to the insurance acknowledgement. Should you experience difficulties when fitting your KeySafe, please call our Sales Support team on 01905 770 333, who will be happy to help.
Supra UK Limited have provided the best fittings for the installation of your GE KeySafe™ and recommend that you fit your GE KeySafe™ in a covert position using a 5-7 digit code.
Prior to fitting, follow instructions to enlarge the 4 holes in the back of the KeySafe, enabling the screws to pass through the vault.
Using the instructions and mounting template provided, mark and drill 4 holes into the brickwork. To do this, use a 5mm masonry bit for the C500, or a 4mm masonry bit for the Permanent and Slimline. Take care NOT to drill into the mortar but into the solid part of the brick. If using the optional alarm sensor, refer to section E of the fitting instructions provided.
Now place the masonry screws through the vault and use a P2 Screwdriver bit to secure your GE KeySafe™ to the wall.
Simply enter your code and replace the lid.
Please remember to that you will need to enter your code to open AND close your permanent and slimline KeySafe.
